Sep 6 17:16:59 roamast: wl0.1: remove client from monitor list Sep 6 17:16:59 roamast: wl0.1: disconnect weak signal strength station Sep 6 17:16:41 syslog: wlceventd_proc_event(490): wl0.1: Deauth_ind 74:15:75:74:66:6D, status: 0, reason: Deauthenticated because sending station is leaving (or has left) IBSS or ESS (3), rssi:0 Sep 6 17:16:40 roamast: wl0.1: remove client from monitor list Sep 6 17:16:40 roamast: wl0.1: disconnect weak signal strength station Sep 6 17:13:46 syslog: wlceventd_proc_event(490): wl0.1: Deauth_ind 00:04:4B:2D:60:FF, status: 0, reason: Deauthenticated because sending station is leaving (or has left) IBSS or ESS (3), rssi:0 Sep 6 17:13:46 roamast: wl0.1: remove client from monitor list Sep 6 17:13:46 roamast: wl0.1: disconnect weak signal strength station I looked at the node's /tmp/syslog.log and it doesn't seem to have any relevant info on why it rebooted: On the main router I don't have any relevant logs about this happening. If I reconnect the client it gets back up to 110Mbps but if I don't renew the client's connection, and it stays at 10Mbps, it will crash (reboot) the router after 1min. The way I can quickly force the crash (reboot) is to fetch a huge file from a NAS and it starts downloading it at around 110Mbps and after 2-10min it drops the speed to 10Mbps. Since the router is mounted to the ceiling and is upside down I thought it might be an issue of temperature but I put a 120mm fan stucked to its back to keep it cool and it still is crashing. I tried dirty flashing the old Asus v3.0.0.4.386.41634 but still showed the same behavior. I tried dirty flashing merlin's v386.3_2 but still crashed (rebooted) after a while. The main problem started when I started to notice that "-1 Pilates" Node was dropping from time to time (it's the only one with wifi backhaul). (every flash was followed by settings reset with the WPS button press on boot)Įverything ok so far! It is unfortunate I can't use merlin's FW since it has some useful features but for know it is ok for my immediate needs. I flashed v 3.0.0.4.386_43129 into every node router and I finally managed to add them all. I flashed the Asus v 3.0.0.4.386_43129 into the main router but it still failed at 1%. Unfortunately the logs didn't have any information on why it failed.
Initially I tried flashing merlin firmware v386.3_2 on every router (both main router and nodes) but it always failed at 1% when adding a new node.
0 kommentar(er)
